The Effect of Crane Operating Methods on Generator Performance During Ship Loading and Unloading Processes CTS Bulk Derawan
DOI:
https://doi.org/10.31004/joecy.v6i1.9233Keywords:
Crane Operation, Floating Crane, Generator Performance, Load Management, Ship Electrical SystemAbstract
The loading and unloading operations of the CTS Bulk Derawan floating crane vessel demand a reliable electrical system, especially the high-capacity Tsuji crane support generator during the 24-hour coal transshipment in Muara Berau, East Kalimantan. Simultaneous crane operations have the potential to cause significant electrical load surges. This study analyzes the effect of crane operation methods (alternating vs. simultaneous) on the performance of the Caterpillar 3512B generator and determines the optimal method. Using a true experimental pre-test post-test control group design, purposive sampling targeted four treatment groups (n=16 measurements) during real-life operations. The data collection of direct observation of ECR panel parameters was analyzed using descriptive statistics, the Kolmogorov-Smirnov normality test, Levene's homogeneity test, one-way ANOVA (F=26.764, Sig.<0.001), and Duncan's post-hoc test via SPSS. The results show that simultaneous operation increases the generator load by an average of 593.5 kW versus 165-246 kW in alternating operation (R²=0.870). The conclusion recommends simultaneous operation with optimal load sharing management to balance generator productivity and reliability.
References
Aditya Nugraha, IM, Febi Luthfiani, F., Grangsang Sotyaramadhani, G., & Muhamad Amril Idrus, MA (2022). Analysis of electrical energy and fuel consumption of KMP. XYZ in supporting shipping operations in East Nusa Tenggara, 6(4), 287–294.https://garuda.kemdikbud.go.id/documents/detail/3232320
Akbar, AA (2022). Identification of the causes of overspeed rpm rotation that occurred in the diesel generator crane on the MV. Semangat Mas [Diploma thesis, Semarang Maritime Polytechnic].http://repository.pip-semarang.ac.id/3786/
Amirul, A. (2022). Identification of the causes of overspeed rpm rotation that occurred in the diesel generator crane on the MV. Semangat Mas.http://repository.pip-semarang.ac.id/3786/
Ashari, M. S., Robbi, S. D., Sandi, W. M., & Kristiyono, A. E. (2025). Impression : Jurnal Teknologi dan Informasi Analisis Kerusakan Bearing Turbine Side di Turbocharger Type VTR- 160 pada Auxiliary Engine. 4(1).
Aziza, N., et al. (2024). Introduction to statistics: Analysis of variance (ANOVA) (Issue February).
Caterpillar Inc. (2003). 3512B marine auxiliary engine parts manual (p. 703).https://www.cat.com
EMS-Tech Pacific Inc. (2008). China Communications Construction Company Limited transshipment platform system operating description.
Farhan, M., & Leni, D. (2024). Analysis of the effect of braking load on diesel engine performance. Scientific Journal of Mechanical Engineering, 24(1), 61–72.
Fernanda, M. R., Kristiyono, A. E., Gunarti, M. R., & Robbi, S. D. (2025). Analisis Menurunnya Kinerja Turbocharger Pada Mesin Diesel Generator di Kapal MV . Meratus Sibolga. 4(3), 4788–4796.
Herlambang, SM, Shaleh, MH, & Santoso, AD (2019). Kapasitas Generator Di Kapal Latih Bung Tomo Poltekpel Surabaya Oleh : 4(2), 19–28.
Lutfi Adi Prabowo, LA, Abdi Seno, A., & Darul Prayogo, D. (2021). The effect of ship operations and generator operation on electrical power loads. Marine Dynamics, 12(2).https://doi.org/10.33772/djitm.v12i2.18275
Marzuki, S., & Wair, FY (2020). Operator performance and reliability of HMC equipment on dry bulk loading and unloading productivity. Jogja Maritime Science Magazine (MIBJ), 18, 23–36.
Nur Wijayanti, E. (2021). Analysis of load changes on generator performance at PT. Pembangkit Jawa Bali (PJB) – Gresik Generating Unit [Final project]. Muhammadiyah University of Surakarta.https://eprints.ums.ac.id/90376/
Royyan. (2018). Analysis of hopper effectiveness on bulk cargo unloading speed at the Special Port of PT. Semen Indonesia, Tuban Branch, 7–12.
Senofri, Windhu Nugroho, H., & Hamzah. (2018). Study of coal loading using floating crane PT. Mutiara Jawa 1 on the mother vessel Vision Muara Berau, East Kalimantan Province (Study of coal loading using floating crane PT. Mutiara Jawa 1 on). Journal of Mineral Technology, 6(1), 27–31.
Sianturi, R. (2025). Normality test as a condition of hypothesis testing. Sigma Mathematics and Learning Journal, 11(1), 1–14.
Sugiyono. (2019). Descriptive statistics. In Educational research methods (2021 ed.). Alfabeta.
Sunarlik, W. (2021). The working principle of a synchronous generator. November Journal (2011), 1-17.
Suryadi, A., & Dwi, B. (2023). Conveyor damage during coal transhipment activities at PT. Indo Tambangraya Megah. Jurnal Saintek Maritim, 23, 193–200.https://jurnal.unimar-amni.ac.id/index.php/JSTM/article/view/336
Syahroni, MI (2022). Quantitative research procedures. Al Musthafa eJournal, 2(3), 43-56.
Tahir, M., Jahrir, AS, Patak, AA, Jafar, MB, & Jabu, B. (2024). Introduction to quantitative descriptive statistical data analysis in completing final assignments for English language education students at Maros Muslim University. 5(4), 2363–2373.
Tsuji Heavy Industries Co., Ltd. (2010). BEIS3526 four-rope grab type deck crane – Technical manual (p. 286).
Vega F. Andromeda, & Danang Wahyu Pratama. (2018). Handling of loading and unloading with ship crane on MV. Oriental Jade. Maritime Dynamics, 8(2), 2011–2028.https://doi.org/10.46484/db.v8i2.73
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 Mukhammad Fajar Wahyu Isnani, Nasri Nasri, Sigit Purwanto, Agus Prawoto, Shofa Dai Robbi

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.







