Pengaruh Penerapan Sistem Kalibrasi Peralatan terhadap Kepuasan Pelanggan di Laboratorium Kalibrasi PT. Dakara Prima Indonesia
DOI:
https://doi.org/10.31004/joecy.v6i2.10181Keywords:
Equipment Calibration System, Customer Satisfaction, Calibration Accuracy, Calibration LaboratoryAbstract
This study aims to examine the effect of implementing an equipment calibration system on customer satisfaction at the Calibration Laboratory of PT. Dakara Prima Indonesia. The implementation of the calibration system was assessed through three key indicators: service timeliness, accuracy of calibration results, and responsiveness to customer complaints. A quantitative descriptive approach was employed in this research. Data were collected from 50 customers who had utilized calibration services through a Likert-scale questionnaire. The analysis was conducted using multiple linear regression, including partial testing (t-test), simultaneous testing (F-test), and the coefficient of determination (Adjusted R Square). The findings indicate that partially, only the accuracy of calibration results has a statistically significant influence on customer satisfaction, as evidenced by a t-value of 2.052 exceeding the t-table value of 2.011 with a significance level of 0.046 (<0.05). Meanwhile, service timeliness and responsiveness to complaints do not individually show significant effects. However, simultaneously, all three indicators significantly influence customer satisfaction based on the F-test results. The Adjusted R Square value of 0.381 suggests that 38.1% of the variation in customer satisfaction can be explained by the variables examined in this study, while the remaining 61.9% is affected by other factors outside the research model. These results highlight the important role of calibration system implementation in enhancing customer satisfaction, with calibration accuracy emerging as the most dominant factor. Therefore, improving consistency and technical quality of calibration outcomes should become a strategic priority
References
Badan Standardisasi Nasional. 2017. SNI ISO/IEC 17025:2017 Persyaratan Umum Kompetensi Laboratorium Pengujian dan Kalibrasi. BSN. Jakarta.
Evans J.R dan Lindsay W.M. 2017. Managing for Quality and Performance Excellence. Cengage Learning. Boston.
Ghozali Imam. 2018. Aplikasi Analisis Multivariate dengan Program IBM SPSS. Badan Penerbit Universitas Diponegoro. Semarang.
Juran J.M dan Godfrey A.B. 1999. Juran’s Quality Handbook. McGraw-Hill. New York.
Kotler Philip dan Keller Kevin Lane. 2016. Marketing Management. Pearson Education. New Jersey.
Lupiyoadi Rambat. 2013. Manajemen Pemasaran Jasa. Salemba Empat. Jakarta.
Montgomery Douglas C. 2013. Introduction to Statistical Quality Control. John Wiley & Sons. New York.
Parasuraman A et al. 1988. SERVQUAL: A Multiple-Item Scale for Measuring Consumer Perceptions of Service Quality. Journal of Retailing.
Sanusi Anwar. 2017. Metodologi Penelitian Bisnis. Salemba Empat. Jakarta.
Sugiyono. 2019. Metode Penelitian Kuantitatif, Kualitatif dan R&D. Alfabeta. Bandung.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 Zogi Syahna Silaen, Wirda Novarika, Siti Rahma Sibuea

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.







